Wall switch module
Full compatibility with 3rd party vendors

Control up to 60 switches with a single wall switch panel


You can use the InfoControl wall switch panel to control up to 60 functions performed by traditional switches. Use our standard switches or integrate with 3rd party vendors, like Clipsal, BTicino, Siemens, or other switch manufacturers.

Devices that are to have their loads switched using the wall switch module must be connected via a switchbox.
The InfoControl switch module is built to handle up to 16 low voltage physical switches. The physical switches can be «layered » to provide 4 logical levels, each of which can be individually programmed.

Programming of the switches and states of the LED’s is achieved using the InfoControl management software. LED’s indicate the state of each switch.
 
The wall switch control module with onboard microcomputer.
Large Image

Example
switch panel configurations

Large Image
If you have existing switches, these too can be integrated with the module. We have chosen one set that matches optically with the design of our sensors, but you are free to integrate it with thousands of different designs and standards.

The switch module is attached with a flat band cable to the control module. Additionally to the 16 possible inputs the module provides 16 outputs for LED's that are independently programmable to indicate the actual status of the switches.

Copyright notice:
Website and content: Copyright 2001, 2002 InfoByte AG *Microsoft is a trademark from
Microsoft Incorporation *InfoControl is a trademark from InfoByte AG.

Technical specifications are subject to change without prior notice.